Home Page

 
All Components meet NFPA 13 D Requirements
  • Rotationally molded polyethylene
  • Meets FDA Reg. 21CFR177.1520 (Potable)
  • Metal bands for additional strength
  • One piece construction - no seams to split
  • Auto fill on each tank
  • Not affected by anti-freeze solutions
  • Built-in hand grips
  • 29" wide tanks fit thru existing doorways

Sizes

  • 300 Gallon - 24x64x66H w/notch-out for controls
  • 450 Gallon - 29x80x66H w/notch-out for controls
  • 550 Gallon - 29x80x66H
  • 1100 Gallon - 86 Diameter x 57H
  • 1500 Gallon - 86 Diameter x 74H
  • 1650 Gallon - 86 Diameter x 80H
  • Other sizes are available
  • Single stage centrifugal pump
  • Built to Hydraulic Institute standards
  • Meets NFPA 20 hydraulic performance specifications (not NFPA listed)
  • 304SS construction for corrosion resistance
  • Motors built to UL standards
  • Built-in overload w/auto-reset provided
  • 115/230 volt single phase
Basis/Standard Controllers
  • NEMA 1 enclosure steel cabinet
  • Factory assembled and tested
  • UL listed PER 508
  • HP rated AC contractor
  • Dual voltage, 115/230 volt single phase

Standard Controller Only

  • 3-way operation swithch (Manual/Off/Auto)
  • Built-in alarm test circuit (110 volt)
  • Minimum run timer

13R Contoller Only

  • UL listed for NFPA 13D & 13R applications
  • Minimum run timer
  • Built-in circuit breaker
  • Fail safe drop out relay circuit
  • NEMA 2 drip proof enclosure
  • Wiring is enclosed in Liquite conduit
  • Butterball valve w/tamper switch
  • Ball valve w/lock & cable
  • Rubber face check valve
  • Backflow preventer
  • Flow switch w/retard, two sets of contacts
  • Pressure switch
  • Globe valves
  • Float valves
  • Water Gauge
  • Galvanized pipe & fittings (copper optional)

HOME I THE D SYSTEM I FREQUENTLY ASKED QUESTIONS I SPECIFICATIONS I INSTALLATION I CONTACT US